It is not advised to mount the supasock in the centre of the bonnet or where it could distract the direct vision of the driver.
For both fittings always make sure that you have cleaned the surface to be affixed to, before attaching the lever suction cup.
Wing (fender), bonnet (hood) or roof fitting
This fitting uses the proven lever suction cup which adheres perfectly to clean smooth flat painted bodywork. Always check that the plastic aerial is pushed tight into the lever suction cup holder and that the suction cup has stuck fast after the lever is pushed down.
Instructions of fitting the supasock onto the aerial are on the back of the pack.
Wing mirror fitting
This fitting has a strong suction cup which fits on the flat glass side of any wing mirror. Ideally it should be located towards the outer edge and towards the bottom of the wing mirror so as to leave a wide area of vision. Make sure the suction cup isn’t impeded by the mirror surround.
The fitting has its own aerial and when the suction cup is initially applied to the mirror, the aerial may rest on the wing mirror surround. However when in motion the aerial will lean back and clear this.
Instructions of fitting the Supasock onto the aerial are on the back of the pack.
Fitting:
1. Wipe surface clean and dry before attaching the suction pad.
2. For best results use on flat shiny surfaces.
3. Every few days check suction pad, clean surface and re-apply.
Not suitable for children due to small parts.
This is not a toy.
Fitting your Supasock
Need any help? Call 01727 826 800 or email info@marketingshop.co.uk